Evo x cd software

Press the [INFO] button. The screen will vary depending on which language setting you select. CDDB version information will be displayed as [xxxx-xxxx].

Please take a note of the number of the version information. After decompressing, save three files with the extensions ". UDT" ". UDX" and ". Confirm that the ". Load the version update data from the vehicle's HDD navigation system. To prevent this, turn off any devices that use the battery, such as lights, air conditioner, etc.

Turn the engine switch to the ON position. Insert the disk containing the version update. Insert the version update disc created in Step 2 which contained data in "Data1. A version update progress screen will be displayed, and the update will begin. The version update will take up to 35 minutes. So even if the car has enough voltage to start, it may not be enough voltage for the reflash portion of the diagnostic cable.

Therefore I highly recommend that you have a battery charger connected whilst doing reflashes, or have the car run for at least 1 hours driving to get the battery voltage level really high. If you are running the car between flashes on a dyno for instance, then this should be sufficient. Try and keep the battery level above Troubleshooting Reflash: Does your cable datalog ok?

If the voltage regulator is bad in the cable and not sending 12volts to flash connector, check this some people have added a switched 12volts for flashing and works fine.

More information about the reflash pin 26 here. Notes: Some Mitsubishi roms on the internet change a special "Init Code" inside the rom, which stop you from re-reflashing the ecu. Shopping Cart Show Cart. Start or Stop the collecting of data from the Zt2. Move page by page up or back through the data. Move to the beginning or end of the logged data. Grab the screen and slide it where you want it. Must press the space bar first to pause scrolling. Right Click over plot name.

Change the data display on this row to plot, gauge or text. Right Click plot area. Mark a datapoint on the screen at that location. Remove the last marked datapoint from the screen. Copy the screen to the clipboard. Set the screen to show as a plot, overlapped plots, dashboard, or text. Download PDF 2. Ethanol Content Analyzer. MegaSquirt PDF 2. The WinLog generic logging software platform.

Logging, tuning, and reflashing of modern engine computers ECUs.